2024 Honda Hrv Wiper Blades How To, by Car Maintenance And Fishing on YouTube. 4 min 33 s.
- Video length
- 4 min 33 s
- Time to do it
- 10 minutes
- Difficulty
- Easy
- Steps
- 8
What you need
Steps
Park on level ground, turn off the ignition, and leave the wipers in their normal parked position. Check the owner's manual if Honda lists a wiper service position.
Lift the driver-side wiper arm away from the windshield until it stays up. Lay a folded microfiber cloth on the glass under the arm.
Find the release tab where the blade meets the arm. Press the tab firmly and slide the old blade down and away from the arm.
Compare the old blade with the new one. Match the length and connector type, and fit any adapter supplied with the new blade.
Slide the new blade onto the arm until it clicks or locks into place. Tug it gently to confirm it is secure.
Lower the arm slowly onto the glass. Do not let it snap down, because the bare metal can crack the windshield.
Repeat the same steps on the passenger side. Check the owner's manual for the correct length, since the two sides can differ.
Turn on the wipers and run them at low speed. Spray washer fluid and check for streaks, chatter, or loose blades.
Tips and common mistakes
Replace both front blades at the same time so they wear evenly.
Clean the windshield and wipe the rubber edge before you judge the new blades.
If a new blade chatters, check that the arm is not bent and the glass is clean.
Questions
What size wiper blades does a 2024 Honda HR-V use?
Sizes can vary by trim and whether you have a rear wiper, so check the owner's manual or a blade fitment chart before buying.
How often should I replace the wiper blades?
Replace them about every 6 to 12 months, or sooner if they streak, chatter, or leave missed patches.
Can I replace just the rubber refill?
Some blades allow a refill, but most replacements are complete blade assemblies. Follow the blade maker's instructions.
This guide was drafted from the video's details and general task knowledge. It has not been checked against the full video. Check the video and relevant product instructions before following a procedure. Report a correction.
