How to clean the sensors on the whisker litter robot 5 pro #robotpet #smartpet, by Matt's Robotics & Pet Products on YouTube. 2 min 35 s.
- Video length
- 2 min 35 s
- Time to do it
- 10 minutes
- Difficulty
- Easy
- Steps
- 8
What you need
Steps
Unplug the Litter-Robot from the wall and let the globe finish any cycle before you touch it.
Press the release button and lift the globe off the base, then set it aside on a flat surface.
Look at the base opening and find the sensor windows and the small openings around the rim.
Brush loose litter and dust out of the sensor openings with a dry soft brush or a short burst of canned air.
Wipe each sensor window with a dry lint-free cloth. Dampen the cloth slightly if there is stuck film, then dry it.
Check the drawer full sensors and the bonnet contacts and wipe them the same way.
Let every surface dry fully, then set the globe back on the base until it clicks into place.
Plug the unit back in and run a manual cycle to confirm the sensors read correctly.
Tips and common mistakes
Clean the sensors every two to three weeks, or sooner if you see false full or cycle errors.
Never spray cleaner or water directly into the sensor openings.
Use a dry cloth first, since wet residue attracts more litter dust.
Questions
How often should I clean the sensors?
About every two to three weeks is enough for most homes. Clean sooner if the app shows errors or the unit stops mid-cycle.
Can I use cleaning spray on the sensors?
No. Use a dry or barely damp cloth only, because liquid can get inside the sensor openings and damage them.
What if errors continue after cleaning?
Recheck that the globe sits fully on the base and the contacts are clean. If errors persist, contact Whisker support.
This guide was drafted from the video's details and general task knowledge. It has not been checked against the full video. Check the video and relevant product instructions before following a procedure. Report a correction.
