HOW TO WATERPROOF YOUR COODY 17.2 FAMILIA PRO INFLATABLE LUXURY TENT FREE & EASY!, by Camp With Nate on YouTube. 2 min 45 s.
- Video length
- 2 min 45 s
- Time to do it
- 2 to 3 hours
- Difficulty
- Easy
- Steps
- 8
What you need
Steps
Pitch the tent fully and inflate all beams. Remove the inner tent or leave it open so you can reach the fly, seams, floor and beam sleeves.
Brush off dirt and sand, then wash the fabric with mild soap and lukewarm water. Rinse well and let the tent dry completely before treating it.
Inspect seams, corners, guy-line patches and the floor for wear, pinholes or peeling tape. Repair damage with a tent repair patch before waterproofing.
Apply silicone seam sealant to the inside of exposed seams with a small brush. Work it into the stitching and let it cure as the label says.
Shake the tent waterproofing spray and test it on a hidden patch. Hold the can 6 to 8 inches away and apply a thin, even coat to the fly and beam sleeves.
Let the first coat dry, then add a second light coat to high-wear areas such as the floor, corners and the top of the tent. Avoid valves and zipper teeth.
Re-waterproof the floor with a tent-safe spray or brush-on treatment. Keep it off the inner floor if you sleep directly on it, and let it dry fully.
Check that water beads on the fabric. If it soaks in, add another thin coat. Let the tent cure in a dry, ventilated place before packing it away.
Tips and common mistakes
Never use household detergent, bleach or a pressure washer on tent fabric; they strip the water-repellent finish.
Spray in shade and on a calm day so the treatment goes on evenly and does not drift onto cars or plants.
Waterproofing does not fix a seam that has pulled apart; seal or patch the seam first.
Wear gloves and a mask and work outdoors or in a well-ventilated space.
Questions
How often should I waterproof the tent?
Re-treat it at the start of each camping season, or sooner if water stops beading and the fabric looks wet through.
Can I use waterproofing spray on the inflatable beams?
Yes, use a tent-safe spray on the outer beam sleeves, but keep it away from valves, freshly sealed seams and zipper teeth.
Do I need to seal the seams as well as spray the fabric?
Yes. Spray restores surface water repellency, while seam sealant fills needle holes and stops leaks at stitched seams.
This guide was drafted from the video's details and general task knowledge. It has not been checked against the full video. Check the video and relevant product instructions before following a procedure. Report a correction.
