How to Trim a Goatee | Wahl, by WahlHomeProduct on YouTube. 2 min 47 s.
- Video length
- 2 min 47 s
- Time to do it
- 15 minutes
- Difficulty
- Easy
- Steps
- 8
What you need
Steps
Wash and dry your beard so the hair lies flat and is easier to cut evenly. Comb it straight down to see the natural shape.
Decide where the goatee starts and ends. A common shape covers the chin and the area around the mouth, leaving the cheeks and jawline clean.
Oil the trimmer blades with a few drops of trimmer oil and run it for a second. This keeps the cut smooth and protects the blades.
Fit a longer guard first, such as 6 to 10 mm, and trim the whole goatee against the direction of hair growth.
Step down to shorter guards to shape the sides and blend the edges. Go slowly and check the mirror between passes.
Remove the guard and use the bare blade to clean the cheeks, jawline and neck below the goatee. Keep the blade flat against the skin.
Trim the moustache part with a short guard, then comb it down and even out any stray hairs with small snips.
Brush the beard, apply a few drops of beard softener or oil, and comb it into shape.
Tips and common mistakes
Start with a longer guard and work shorter, since you cannot put hair back once it is cut.
Trim against the direction of hair growth for an even finish.
Clean the trimmer blades after each use and oil them to keep them sharp.
Take a photo or mark the guard length you like so you can repeat the same look next time.
Questions
Can I shape a goatee with a regular hair clipper?
Yes, a clipper with small guards works, but a trimmer with a narrow blade gives more control around the mouth and edges.
How often should I trim my goatee?
Most people trim every one to two weeks to keep the edges clean and the length even.
What guard length should I use for a short goatee?
Try a 3 to 6 mm guard for a short goatee and a 10 mm guard or longer for a fuller look.
This guide was drafted from the video's details and general task knowledge. It has not been checked against the full video. Check the video and relevant product instructions before following a procedure. Report a correction.
