How to repair a hole in a jumper invisibly by hand

What you need

• Matching yarn or thread
• Blunt tapestry needle
• Small scissors
• A darning mushroom or a smooth round object

Steps

1. Turn the jumper inside out and stretch the hole gently over a darning mushroom or a smooth jar so the edges sit flat.

2. Pick a yarn that matches the jumper in colour and thickness. Split the yarn in half if it looks thicker than the knit.

3. Thread the needle and tie a small knot at the end. Start from the inside so the knot stays hidden.

4. Bring the needle up just outside the hole and work small stitches back and forth across the gap, following the knit rows.

5. Keep the stitches loose. Pulling tight will pucker the fabric and make the mend show.

6. Work in the other direction, weaving over and under the first stitches to rebuild the knit texture.

7. Extend the stitches a few millimetres past the hole on each side so the repair grips solid fabric.

8. Finish on the inside, tie off, and trim the yarn close to the knot.

9. Turn the jumper right side out, stretch the area gently and press it flat with your hand.

Tips and common mistakes

Questions

Can I fix a hole without matching yarn?

Yes. Unpick a short length from an inside seam or hem of the same jumper and use that. It will match perfectly.

Will the repair show after washing?

A loose, even mend usually blends in. Tight stitches can pucker, so keep the tension soft and reshape the jumper while it dries flat.

What size hole can this fix?

This method suits small holes up to about a centimetre. Larger or frayed holes need a patch or a full darn.

This guide was drafted from the video's details and general task knowledge. It has not been checked against the full video. Check the video and relevant product instructions before following a procedure. Report a correction.